Highly conductive materials like aluminum require very high power to form quality spot welds. However aluminum alloys are routinely spot welded (see Table I for weldability). Here, cleanliness is much more of a concern than with low-carbon steels because of aluminum’s rapid surface oxidation characteristics. For optimum quality and weld performance, expensive cleaning procedures to remove surface oxide are required. For demanding applications, equipment to monitor surface resistivity from lot to lot is necessary to assure consistency of quality. This leads to a related consideration. If aluminum has been chosen for an important reason, such as lightweight or high strength-to-weight ratio, the added expense of ensuring a high-quality weld should be justified. If it has not, re-evaluation of the original material selection is in order or, perhaps, another assembling method should be considered.
Plug welding is an alternative to spot welding used by vehicle manufacturers where there is insufficient access for a spot welder. For DIY car restoration it’s generally used instead of spot welding on panels flanges that would have originally been spot welded. Plug welds when done properly tend to be stronger than the original spot welds. Rally car builders often use the technique, and it is acceptable in a UK MOT test as an alternative to spot welds where repairing older cars (it would not be suitable for modern high tensile steels).
Spot welding is a resistance welding process that is used primarily for welding two or more metal sheets together by applying pressure and heat to the weld area. It works by contacting copper alloy electrodes to the sheet surfaces, whereby pressure and electric current are applied and heat is generated by the passage of current through resistive materials such as low carbon steels. Read extra info at Tecna Spot Welder Parts.
To make sure your welding settings are correct, you should carry out a test run using metal offcuts, followed by a destructive test where you separate the welded parts with a hammer and a forked chisel. After separation, a hole must be made in one of the two conjoined sheets – a process known as “unbuttoning” in metalworking jargon – as proof that the settings are right for the metals and thicknesses involved. Apologies for the abstruse technical term! When welding radiators, make sure you also carry out a leak test.